光猫和路由器，N1公用电源，光猫1000M口失效？ - Optical cat and router, N1 public power, 1000m port failure of optical cat?

网友回复网友：

注册网友： 电信的我这么接，没问题。

Geekman网友： 直流电进线就正负，哪来公共G

陈浩南网友： 我也是0755电信，路由B70 12v6a 一分四 ，还接个3.5硬盘。 但是测试只要接上N1,就光猫 1000M口 失效

h2o网友： 好像有道理

Geekman网友： N1的开启线刷模式电压有点问题，反正我K2P  lao 毛子刷N1时候，两次插网线都把K2P固件冲没了，直接黑灯。要进BREED重刷才行 还有一个问题就是线刷模式，用双工头线也能当供电线使用。是不是这个原因导致网线口，电源线口，USB是通的？

12v6a and then a quarter. Yesterday, I found a problem. The optical cat can connect a power supply to the router, but the 1000m port of N1 optical cat fails. Is it the cause of common ground? The reference voltage of some Baidu's devices must be suspended. If they share the ground with other interconnected devices, there will be problems. Copy code netizen reply: Register: I of telegraphic so receive, no problem. Geekman: the DC incoming line is positive and negative. Where is the public g Chen Haonan? I'm also 0755 Telecom. The route is B70 12v6a, one quarter, with a 3.5 hard disk. However, as long as N1 is connected to the test, the 1000m port will fail. H2O: it seems reasonable that geekman: N1 has some problems with the mode voltage of starting the wire brush. Anyway, when I brush N1 with K2P Lao hair, the K2P firmware will be washed away by the two patch cords, and the light will be black directly. There is also a problem that we need to use the brush mode when we need to use the brush again. We can also use the duplex head line as the power supply line. Is this the cause of the network cable port, power cable port, USB is through?

这几篇文章你可能也喜欢：

• 暂无相关推荐文章

本文由主机参考刊发，转载请注明：光猫和路由器，N1公用电源，光猫1000M口失效？ - Optical cat and router, N1 public power, 1000m port failure of optical cat? https://zhujicankao.com/5607.html